Sezione di Padova
Contributo alla costruzione dei layers 6,7
Possibili task per PADOVA:
 precedente proposta: R&D della procedura di
assemblaggio degli staves, inclusa la produzione del
tooling e la realizzazione del prototipo della stazione di
assemblaggio degli staves;
 nuova proposta: R&D integrazione degli staves in halfbarrel e distribuzione dei servizi, incluso lo sviluppo e la
messa a punto del tooling e della procedura di
integrazione. Produzione del prototipo 0 di half-barrel?
11 Aprile 2013
INFN Upgrade Meeting
Sezione di Padova
Risorse di personale
Risorse di personale per attività di meccanica layers 6-7
• Officina di progettazione meccanica:
 M. Benettoni, con il supporto di A. Pepato
 1 disegnatore meccanico equivalente
 1 figura di ingegnere meccanico TD dedicata all'attività
per i prossimi 3-4 anni
 contributo ulteriore del personale dell’officina di
progettazione meccanica ove necessario
• Officina meccanica
 1-2 tecnici equivalenti
11 Aprile 2013
INFN Upgrade Meeting
MORE INFO
(slides S. Moretto, 21 marzo)
11 Aprile 2013
INFN Upgrade Meeting
Padova Contributions
for the whole ITS Upgrade Project
 Physics - Simulation (WP1 – WP2)
Topics: Future physics programme of the experiment and simulation studies to assess the
expected performance of the ALICE detector, with the new ITS.
A. Dainese is the coordinator of the WP1 and he strongly participated to the CDR draft.
Declared interest for the simulation software development for the Monolithic pixel detectors
characterization.
 Characterization and Qualification - Readout Electronics (WP5 – WP10)
Topics: Development of hardware and software for the characterization of PIXEL chip and entire
module and data transmission.
Development and realization of test setup for the pixel chip and modules.
P. Giubilato is the coordinator of the WP10 (data transmission).
 Mechanics and Cooling (WP11)
Topics: Development of mechanics and cooling for the upgrade ITS. Studies on Silicon microchannels cooling with the PhD Francescon and the engineer D. Del Col.
 Outer Layers (6,7) Module (All) – WP8
-> Tasks and perspectives to be discussed
March 21 2013
INFN Upgrade Meeting
Padova Perspectives:
Structures and Facilities
Structures and Facilities:
• Clean room equipped with a
Mitutoyo measuring machine for the
installation of the prototypes and for
testing assembly procedures.
• Active Scanner machine Zeiss
Accura placed in the mechanical
shop for the qualification of the
produced tools and jigs.
Sizes 800x2000x1000 mm3
Bridge Type
Accuracy (2.3+3L/1000)µm
Probe and Optical Measurement
Sizes 1200x1800x1000 mm3
Accuracy from 1.6um + L/333
Active Scanning, Passive
Scanning and Laser Scanning
• Another clean room of 70 mq equipped with Johansson measuring
machine available at Legnaro Laboratory
• Electronic laboratory for the development of the test setup
March 21 2013
INFN Upgrade Meeting
Padova Perspectives:
Electronic
Laboratory
Clean room
(with measuring
machines)
All located at Physics
Department
“door to door”:
Engineerin
g Office
Mechanical
Shop
Very useful to fast manage
the proposed tasks for the
WP8
(designs, production,
qualification, tests, etc..)
Significant experience in the past SPD project:
mechanics, production, qualification, assembly and integration
Important possibility to easily exchange information with the other
interconnect WPs in Padova
March 21 2013
INFN Upgrade Meeting