2011-2012 FALL SEMESTER ME211 INTRODUCTION TO DC/AC CIRCUIT LECTURE PROJECT DECEMBER 2011 TITLE OF PROJECT (ARIAL, 40 PUNTO, BOLD) Student Name-Surname, Student Name-Surname Student Name-Surname, Student Name-Surname Student Name-Surname(ARIAL, 24 PUNTO, BOLD) Lecturer Name-Surname (ARIAL, 24 PUNTO, BOLD) University of Gaziantep, Mechanical Engineering Department (ARIAL, 24 PUNTO, BOLD) INTRODUCTION (ARIAL, 28 PUNTO, BOLD) Figure 2 A brief information on the project topic will be given in this section. (Arial 28 punto) PART LIST (ARIAL, 28 PUNTO, BOLD) Figure 2. Soldering 2(Arial 28 punto) Part list of the project will be given in this section. (Arial 28 punto) CONCLUSION (ARIAL, 28 PUNTO, BOLD) Assemble project will be given in this place with small conclusion eg. All of the parts are soldered to the plate and ….. Project is produced. Assemble of the «topic» is shown in Figure 3. (Arial 22 punto) PRODUCTION STEPS (ARIAL, 28 Figure 3 PUNTO, BOLD) Figure 1 Figure 1. Soldering (Arial 28 punto) Figure 3. Assemble (FİNAL VİEW) (Arial 28 punto)