This leaflet is purely for illustrative purposes and may not reflect correctly the supplied parts. The manufacturer reserves
to amend the contents of it whenever necessary and without notice.
Distributed by:
VB air suspension
Varsseveld-Holland
Frankenweg 3
Varsseveld-Holland
4.0161-IM-VB-ENG
Until 12/1996
MERCEDES 307 D - 310 D
Rear integrative pneumatic suspension for
1520201001
VB-Airsuspension ref.
ENG
1
Place the vehicle in a hole or
bridge, to operate SAFE and
comfortably.
RIGHT SIDE
cap
Valve body
TOP DRIVE
CONTROL
Support
plate
Ringnut
2
Remove rebound pad and give to
the end user.
RIGHT SIDE
3
Pneumatic system
instruction (1x)
Place the locking plate provided
inside rebound pad support.
RIGHT SIDE
Clips kit Composed
by:
• Plastic clips (20x)
Pressure stick (1X)
Plate (1X)
Locking plate (2X)
Plate (1X)
SMALL HARDWARE KIT
M10x25 (4x)
PRESSURE CONTROL KIT
Composed by:
• Valve body with pipe fittings
(2x);
• Inflating valves (2x);
• Caps (6x);
• Caps (for manometers) (2x). • Support plate (2x);
• Ringnut (2x).
• Gauge support (1x)
RILSAN KIT PIPE composed MANOMETERS box composed by:
by:
• Manometers with plastic
• Red pipe (6m)
ringnut (2x);
• Black Pipe (6m)
Right suspension (1x)
Left suspension (1x)
Passacavo (2X)
Grommet (2X)
Ø 80 (2x)
PACKAGE CONTENT
INSTALLATION INSTRUCTIONS
4
1
3
Position of the drive adjustor modified correcyly.
WARNING : For the execution of the pneumatic system, please strictly refer the specific given instructions. In fact , the system may
vary according to the chosen version (manual, self levelling or electrical); so than the instructions for the pneumatic system are stated in
the apposite handbook enclosed at the purchased kit.
IMPORTANT: do NOT use liquid Teflon®, hemp, paints etc. .In case of problem and/or information, contact our technical office. In case
you fail to comply at this indications, societies EUROSERVICE s.r.l. and ESI Italia s.r.l. aren’t responsible for eventually damages derivates.
For further information contact us.
Put the work pressure stick in a place visible for the driver, in
the cabin.
NOTE: for the execution of pneumatic system, follow
specific instructions not included in this manual. See the
“pneumatic system: installation instructions” form (see
picture right).
Place in between the holed plate and
lock by mean of screws and bolts as
showed in picture.
2
6
Lock the suspension on the axle
with provided clamps..
RIGHT SIDE
BRAKE REGULATOR MODIFICATION INSTRUCTION
7
5
Lock the suspension on the locking
plate with provided screws..
RIGHT SIDE
Fit RILSAN pipe on suspension pipe fitting: :
• Red for right side
• Black for left side.
Unscrew the side fixed to the axle of
the adjustor drive rod, as showed on
the picture.
RIGHT SIDE
Place the suspension between axle
and chassis ( center holes in the
locking plate ).
RIGHT SIDE